10
WARNING:
Do not allow familiarity with your drill-driver to
make you careless. Remember that a careless
fraction of a second is sufficient to inflict severe
injury.
CHARGING BATTERY PACK
The battery pack for this tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it until the light on front of charger
changes from flashing green to continuous green.
Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (drilling followed by
recharging) for them to become fully charged. This is normal
for nickel-cadmium batteries.
TO CHARGE
n
Charge battery pack only with the charger provided.
n
Make sure power supply is normal house voltage, 120
volts, 60 Hz, AC only.
n
Connect the charger to a power supply.
n
Attach battery pack to charger by aligning raised ribs on
battery pack with grooves in charger, then slide battery
pack onto charger. See Figure 2.
n
After normal usage, 20 minutes of charging time is
required to be fully charged.
n
The battery pack will become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
n
Do not place charger in an area of extreme heat or cold.
It will work best at normal room temperature.
n
When the batteries become fully charged, unplug your
charger from power supply and remove the battery
pack.
IMPORTANT INFORMATION FOR RECHARGING
HOT BATTERY PACK
When using your drill continuously, the batteries in your bat-
tery pack will become hot. You should let a hot battery pack
cool down for approximately 30 minutes before attempting
to recharge. When the battery pack becomes discharged
and is hot, the green LED will be off and the red LED will
begin flashing.
When the battery pack cools down to approximately 104°F
(40°C), the charger will automatically begin fast charge
mode.
If the Red LED continues to flash for more than 90 minutes,
and the green LED remains off, this may indicate a damaged
battery that will not charge.
OPERATION
Fig. 2
IMPORTANT INFORMATION FOR RECHARGING
COOL BATTERY PACK
If battery pack is below normal temperature range, the red
LED will begin flashing and the green LED will be off. When
the battery warms to a temperature of more than 41°F (5°C),
the charger will automatically begin fast charge mode.
Note: Refer to "CHARGING BATTERY PACK" for normal
recharging of batteries. If the charger does not charge your
battery pack under normal circumstances, return both the
battery pack and charger to your nearest repair center for
electrical check. For the location of your nearest repair cen-
ter, please call 1-866-539-1710.
CAUTION:
To prevent damage to battery pack, remove battery
pack from charger immediately if no LED comes
on. Return battery pack and charger to your
nearest service center for checking or replacing.
Also, if you are removing battery pack from
charger and no LEDs are on, return both battery
pack and charger to your nearest service center.
Do not insert another battery pack into charger. A
damaged charger may damage a battery pack.
