31
ADJUSTMENTS
0° BEVEL ADJUSTMENT
See Figure 42.
NOTE:
These adjustments were made at the factory and
normally do not require readjustment.
Unplug the saw.
Loosen the bevel lock knob by turning the knob
counterclockwise.
Square the blade to the miter table as described in the
Assembly section of this manual.
If the blade is out of square, adjust by tightening or
loosening the 0° bevel stop screw using the 3 mm leg
(long leg) of the hex key.
Retighten bevel lock knob. Recheck blade-to-table
alignment.
Your saw has several scale indicators. After squaring ad-
justments have been made, it may be necessary to loosen
the indicators screws and reset them to zero.
See Figures
19 and 20.
Fig. 42
0° BEVEL
STOP SCREW
HEX
KEY
