13 - English
WARNING:
Always cut in a forward direction when pocket
cutting. Cutting in the reverse direction could
cause the saw to climb up on the workpiece and
back toward you.
Release the trigger and allow the blade to come to a
complete stop.
Lift the saw from the workpiece.
Clear corners out with a hand saw or sabre saw.
WARNING:
Never tie the lower blade guard in a raised position.
Leaving the blade exposed could lead to serious
injury.
WARNING:
Before performing any adjustment, make sure
the tool is unplugged from the power supply and
the switch is in the
OFF ( O ) position. Failure to
heed this warning could result in serious personal
injury.
POSITIVE 0
° BEVEL STOP
See Figure 22, page 19.
The saw has a positive 0
°
bevel stop that has been factory
adjusted to assure 0
°
angle of the saw blade when making 90
°
cuts. However, misalignment can occur during shipping.
To check positive 0
°
bevel stop:
Unplug the saw.
Place saw in an upside down position on a workbench.
Move the lower blade guard out of the way so that the
saw blade is exposed.
Check the squareness of the saw blade to the base of
the saw using a combination square.
ADJUSTMENTS
POCKET CUTTING
See Figure 21, page 19.
WARNING:
Always adjust bevel setting to zero before making
a pocket cut. Attempting a pocket cut at any other
setting can result in loss of control of the saw
possibly causing serious injury.
Adjust the bevel setting to zero.
Set the blade to the correct blade depth setting.
Swing the lower blade guard up using the lower blade
guard handle.
NOTE: Always raise the lower blade guard with the handle
to avoid serious injury.
Hold the lower blade guard by the handle.
Rest the front of the base flat against the workpiece with
the rear of the handle raised so the blade does not touch
the workpiece.
Start the saw and let the blade reach full speed.
Guide the saw into the workpiece and make the cut.
OPERATION
To adjust positive 0
°
bevel stop:
Unplug the saw.
Pull bevel adjustment lever upward to release.
Turn T8 setscrew with hex key (not provided) and adjust
base until it is square with the saw blade.
Securely lock the bevel adjustment lever.
WARNING:
Attempting a bevel cut without having the bevel
adjustment lever securely locked in place can
result in serious injury.
