Installing handle Bracket onto
the Drum
1. Align the handle bracket assembly to
the back of the dust drum assembly as
shown.
2. Install 5 screws (supplied) through the
matching holes on the back of the
handle bracket assembly into the dust
drum.
3. Tighten screws until just snug.
Do not over tighten as this may
deform or damage the handle bracket
assembly or drum assembly.
7
Assembly
(continued)
Screws (5)
Handle
Bracket
Drum
operation
WARNING: to reduce the risk of fire, explosion, or damage to vac:
• Do not leave vac running while unattended - you may fail to notice
important signs indicating abnormal operation such as loss of suction,
debris/liquid exiting the exhaust, or abnormal motor noises. Immediately
stop using vac if you notice these signs.
• Do not leave vac plugged in when not in use.
• Do not continue running when float has cut off suction.
• sparks inside the motor can ignite airborne flammables. Do not operate
vac near flammable liquids or in areas with flammable gases, vapors, or
explosive/airborne dust. flammable liquids, gases, and vapors include:
lighter fluid, solvent-type cleaners, oil-based paints, gasoline, alcohol,
and aerosol sprays. explosive dusts include: coal, magnesium, aluminum,
grain, and gun powder.
• Do not vacuum up explosive dusts, flammable liquids, or hot ashes.
WARNING: to reduce the risk of electric shock or injury:
• Do not expose to rain or allow liquid to enter motor compartment.
store indoors.
• Do not handle plug, switch, or vac with wet hands.
• unplug vac before servicing. If your vac is not working as it should, has
missing parts, has been dropped, damaged, left outdoors, or dropped into
water, return it to an authorized service center or call customer service.
• When using an extension cord, use only outdoor-rated cords that are in
good condition. Do not allow the connection to come into contact with
liquid.
!
!
SP7006 Pro Pack Plus ESF.qxp_SP7006 8/9/16 9:42 AM Page 7
