18
Basic Operations (continued)
WARNING:
To reduce the risk of
injury from unexpected tool move-
ment:
a. Before moving this tool, lock the
power head in the lower position.
Unplug electric cord.
b. To reduce the risk of back injury,
hold the tool close to your body
when lifting. Bend your knees so
you can lift with your legs, not
your back. Lift by using the hand-
hold areas at each side of the
bottom of the base or by the car-
rying handle.
c. Never carry tool by the power
cord or the trigger grip of the plas-
tic handle. Carrying the tool by
the power cord could cause dam-
age to the insulation or the wire
connections resulting in electric
shock or fire.
d. Place the machine so other peo-
ple cannot stand behind it.
Thrown debris could injure peo-
ple in its path.
e. Place the tool on a firm, level sur-
face where there is plenty of
room for handling and properly
supporting the workpiece.
f. Support the tool so the table is
level and does not rock.
g. Bolt or clamp the tool to its sup-
port.
Switch
On/Off Trigger Switch -
To start the tool,
squeeze the trigger. To stop the tool,
release the trigger.
Repositioning the Stationary Vise
The stationary vise can be repositioned
by removing the vise adjustment bolt.
Loosen the miter lock handle and reposi-
tion the stationary vise in one of the other
two hole locations. Replace and tighten
the vise adjustment bolt.The maximum
width capacity is approximately 8-1/4" at
90° and 5” at 45°.
On/Off
Trigger
Switch
Stationary
Screw
Base
Vise
Adjustment
Bolt
Vise
Shaft
Miter Lock
Handle
