RIDGID 205298453, Operator'S Manual

Page: 13 / 100

13 — English
Fig. 7
RIGHT
OUTER TUBE
LEFT
UPPER TUBE
SPACER
LOCK NUT
RIGHT
UPPER TUBE
INNER LEG
ASSEMBLY
AXLE
LOCK NUT
FLAT WASHER,
MEDIUM
STOP PIN
WHEEL
LEFT
OUTER TUBE
HEX HEAD
BOLT
LOWER
BRACE
CARRIAGE
BOLT
ASSEMBLY
FLAT
WASHER, LARGE
ASSEMBLING THE WSUV™ WET SAW
UTILITY VEHICLE / LEG STAND
See Figure 7.
Many of the WSUV™ / leg stand parts are movable. All
hardware must be tightened securely but not so tight that
the utility vehicle / leg stand won’t open and close. For easier
assembly, match letter to letter.

Place a curved spacer over the end of the lower brace.

Insert a hex head bolt and small flat washer at the bottom
of the right outer tube and into the lower brace. Tighten
securely. Repeat for the other side.

Place a carriage bolt through the center hole in the outer
tubes then place a spacer on the bolt.

Slide the bolt/spacer into the inner leg assembly and se-
cure in place using a lock nut. Do not overtighten. Repeat
for the other side.

Place the center brace on top of the inner leg assembly
(curve side up) with the stop pin under the pedal assembly
latch.
NOTE: The stop pins rest on top of inner leg assembly.

Insert a carriage bolt through the top hole of the inner leg
assembly then slide a spacer on the bolt. Repeat for the
other side.
 Slide the center brace onto the bolt and secure in place
using a lock nut. Repeat for the other side.

With the curve handle turned downward, secure the up-
per tubes to the leg stand using carriage bolts, spacers,
and lock nuts.
 Locate the lock nut and two flat washers.

Slide the large flat washer, wheel, and medium flat washer
onto the axle through the hole in the center of the wheel.
Secure in place using lock nut.
 Repeat with the second wheel.
CENTER
BRACE