Page | 8
VIDEO SOUND
Video sound recording can be turned ON or OFF.
1. Select VIDEO SOUND
2. Select ON or OFF and push OK to set
QUIET TIME
Also known as, “Time Interval or Delay Time”, this feature puts the camera to sleep after
capturing an image for the selected period of time before it can be re-activated by motion.
Times vary from 0 seconds to 60 minutes.
1. Select QUIET TIME
2. Select desired
‘quiet time’ and push OK to set
NOTE
: The camera is only able to do one thing at a time; it has one internal processor.
When in cellular mode, the camera must finish transmitting the image before it can
capture a subsequent image. Average transmission speed will range 10 seconds to 1
minutes depending on the network strength at that time and location.
NOTE
: The camera will wait for the Quite Time length before it can be triggered by
motion when first turned ON.
DUTY TIME
This feature allows the user to program the camera to turn ON and OFF at a specified time.
1.
Select DUTY TIME
2.
Select ENABLE to set up Duty Time or DISABLE to cancel Duty Time
SET ACTIVE TIME for each day of week
Set camera ACTIVE time for each your of the day (highlighted RED =
ACTIVE, greyed = NOT ACTIVE)
3.
Push ‘check mark’ to select ALL; Push X to deselect ALL
4.
Push SAVE once complete
Note
: For 24 hour activity: Disable Duty Time
TIME LAPSE
This feature allows the camera to take pictures at a pre-set time interval (5 min to 12 hours)
and record or send them over the network.
NOTE: When in cellular mode, it is important to understand the cellular limitations.
1.
Select TIME LAPSE
2.
Select ENABLE to set up time lapse or DISABLE to cancel time lapse
3.
Set START TIME and END TIME and push OK to set
4.
Set INTERVAL and push OK to set
