声明：本说明书著作权归杭州睿登科技有限公司所有，未经允许任何单位或个人不得用于商业用途。
48
1.4.2.5
System Setting
System setting operation video
：
https://drive.google.com/drive/folders/1JCPJkD92Iv2Qtplmd6rs1pQma
Press
+
to enter the
system setting menu, the icon in Red shows the
menu being chosen,
press
or
to enter the sub-menu, the option in blue
is the option being chosen, you can rotate the encoder potentiometer to change
setting, and you can press
button to select menu.
Press
+
to enter the
system setting menu showed in figure 5,
press
or
to enter the sub-menu.
Settings Sub-menu:
System language
is
is set to English by default
.
You can also set Simplified Chinese, French, Germany
and Russian language;
Take OK
is
set to ON by default
, when you
quickly call out a data group, there will be a prompt
to let you confirm, if you set OFF for this option, the
settings will be edited directly when call out a data group;
Take Out
is set to OFF by default
, when call out a data group, it will keep the
previous output status, when set it ON, it will output directly when call out a data
group.
Boot Power
is set to OFF by default
, when boot the device the output is cut off,
when set it on, it will automatically turn on the output after booting.
Boot Logo
is set to ON by default
, when boot the device, it will show the boot
logo first, then enter the main interface, when set it OFF, it will enter the main
interface directly.
Buzzer
is set to ON by default
,it will show
on the top, and you can hear the
beep when press the button. When set it OFF, it will show
, there will not be beep
when press the button.
Backlight
is set to level 4 by default, it can be set between level 0-5.
Update Rate
is set to Low by default, you can set it low/mid/high, it is the fresh
rate of the real output voltage and current.
Max Power
is set to 740W by default, you can set it between 0-740W, it is the
max output power. On the top you can see the *1 icon, it is the adjustment
magnification, you can press
or
to choose the different
magnification so that
you can set the value quickly, The max output is default voltage priority mode, when
the setting voltage*setting current is higher than the max power, the device will
figure 5
