For the most up to date documents, bike models, additional information, instructional videos,
21
•
Once the bike is powered on, the throttle is active, if pushed it will cause the bike to accelerate. If
PAS is on and at 1 or higher, if the pedals are bumped and move forward when next to or moving
the bike, power will be sent to the motor and the bike will accelerate.
•
Turning it on and off as described above will minimize the chance of the bike accelerating
unintentionally.
•
To turn the headlight on/off, hold the + button.
•
To change to MPH and other settings, enter the menu by hold the ‘+’ and ‘-‘ button at the same time
for 2 seconds.
•
When parking the bike for more than 5 minutes, the e-bike system switches off automatically.
•
The settings can be adjusted by pressing the menu button and reading the prompts on the screen.
•
The throttle and pedal assist can be used simultaneously. The throttle power is not affected by the
pedal assist setting.
•
You can turn the pedal assist off by pressing the – button past low, until no number is showing, and
ride only using the throttle if you like. The bike pedal assist uses a cadence sensor, which reacts a
little delayed based on the spinning of the pedals. It will take some time to get used to this and
manipulating the motor to engage and disengage when expected takes a little practice. You can
adjust the sensitivity in the display settings.
•
A quick backpedal or slight engagement of the brake lever instantly stops the motor.
You can
adjust the sensitivity of the cadence sensor and other pedal assist settings by referring to the LCD
manual. We also have videos on our website and YouTube channel guiding you through this process.
8.
Error Code Troubleshooting:
In the event of a problem with the electrical components of your bike, the display will show an error code.
The error code may only appear briefly when the problem occurs. If an error occurs and you can do so safely,
glance at your screen to see if an error code is present. Compare the code with this list below and
how to
resolve
:
8.1 Error Codes/Source of the Error:
Code
Error
Source of the Error
21
Battery Voltage
The battery is not supplying the required voltage to power the
display and motor. Use the display to view the real-time voltage
being output from the battery. It can also be checked using a
multimeter. If the battery is old and has been charged /
discharged many times, it may need to be replaced.
22
Throttle
When you press and release the throttle, it should return to the
original position. Remove any obstructions. Check the throttle
and throttle cable for damage, such as a cut or frayed cable.