I N T R O D U C T I O N
The Lyne Contour is an adjustable seatpost that allows riders to
adjust their saddle height remotely. This is a high quality product that
has undergone rigorous testing and complies with ISO and EN
standards. The result is a robust design with very little head play.
Step 1. Measure the length of the cable outer housing from the
dropper post (in its final position) to the selected position of the
remote lever. Use sharp side cutters to cut the cable outer to length,
make sure to cut only the outer cable and not the inner at this point.
Leave enough cable at the handlebars to allow for a full 180° of
movement without restriction. Route the cable housing through the
frame until it is sticking out of the seat tube.
Step 2. Thread the inner cable into the cable end nut. Ensure that the
cable end nut is orientated correctly and the cable end is pulled into
the recess, see the diagram below.
Step 3. Add the end caps to the outer cable and insert the inner cable
leaving 12-13mm gap between the cable end nut and the end cap.
I M P O R T A N T N O T E S
I N S T A L L A T I O N
Ensure that you have chosen the correct seatpost diameter for
your bicycle frame. Do not use a seatpost reducer shim with this
seatpost, this will void your warranty and could cause damage to
your dropper post and/or your frame.
If you have chosen an internally routed seatpost then you must
ensure that the bicycle frame has internal dropper post routing.
Do not attempt to modify your frame to allow internal routing,
doing so may cause frame failure which could result in injury or
death and could void your frame warranty.
Please ensure you have the correct travel dropper post for your
frame and seatpost extension combination, check
lynecomponents.com for more info.
Ensure that the seatpost is inserted past the minimum insertion
line. Recommended seatpost clamp torque is 4-6Nm. Over
tightening will result in a malfunctioning dropper due to
compressed internals.
P A C K A G E C O N T E N T S
1
2
3
4
1
2
3
4
Dropper Seatpost
Cable- inner & housing (regular shifter housing and inner)
Remote Lever Assembly
Cable End Nut
Minimum Insertion
Remove inner cable,
only cut outer cable.
Cable end nut
Inner cable
WWW.LYNECOMPONENTS
.COM/VIDEOS
INTERNAL DROPPER POST SERIES
OWNERS MANUAL
Cable end cap
12-13mm
Make sure you have orientated the cable end nut correctly,
the inner cable end should be flush when installed
