4
Installation
This section is intended for the dealer of the FertiMiX Pro C.
This section describes the following subjects:
Installation requirements
Connecting the various components
In section "Step-by-step installation and commissioning instructions" on
page 32 you will find an overview of the steps. Use the Appendix: "Checklist
for step-by-step installation procedure" on page 60 to check that all steps
have been completed.
4.1
Installation requirements
This section describes the requirements for installing the FertiMiX.
4.1.1
Dealer/installer requirements
The installation of the FertiMiX Pro C and the other components, together with the
installation and configuration of the software, must be carried out by a qualified
dealer. Ridder Growing Solutions considers a dealer/installer to be qualified if that
person meets the following requirements:
The dealer:
has successfully completed the Ridder CX500 training courses at Ridder
Growing Solutions.
has a broad knowledge of installation technology (hydronic and electronic).
has experience with Microsoft Windows
®
-operated computer systems (in a
network environment) from version 8 upwards.
can understand and carry out instructions in English.
is familiar with the contents of this installation and user manual.
4.1.2
Installation requirements
The following requirements apply to installing the FertiMiX Pro C on site:
Make sure that the FertiMiX Pro C is level.
Install the FertiMiX Pro C on a hard surface that is able to support its weight.
Install the unit in a dry, dust-free location (1)
1
.
Check the ambient temperature. This should be between 5°C - 30°C (41°F -
86°F) (2).
Check the relative humidity (RV). This may not exceed 85%, without
condensation (3).
Make sure that the unit is not exposed to dripping or splashing water (4).
1
The numbers refer to the numbers in Figure 4-1.
FertiMiX
30
