EM-1010 computerized Embroidery Machine Operation Manual V2.0
20
key to start searching absolute origin. Then it is moved to embroidering position
before power failure and stopped. Draw the bar and it can continue embroidering.
4.4 Embroidery Running Status
In embroidering running status, it can only take spindle lifting speed operation.
Press
key to slow or accelerate the spindle speed. Press
key to
selet lifting speed.
4.5 Bar Drawing Operation
After various embroidering related parameters are finished setting, it can start
embroidering by pressing start key.
Stop at embroidery card status:
press start key once to start embroidering. Press stop
key once to start back stitching.
Back stitching at embroidery card status:
Press stop key once to stop back stitching.
In embroidery card running status:
Press start key for more than 3s, the spindle takes
embroidering in min speed. Press stop key once and it stops embroidering.
4.6 Switch Control and Indicators of Tinsel Machine Head
When tinsel embroidery is used, it must ensure “tinsel using needle bar” of embroidering
parameter has been set correspondingly with mechanical installation needle bar (Off, Left,
Right and Left & Right). Tinsel type is set as “Motor”.
Output and lifting motor can use dial switch to adjust the motor rotation direction. When
the motor is rotated reversely, dial the 3
rd
digit of dial switch SW1/SW2 to take adjustment.
It can select whether the installed landing chassis is on left machine head or right head.
Dial the 4
th
digit of dial switch SW1/SW2 to take switching. ON(0
）
direction is left machine
head and OFF(1
）
direction is right head.
Tinsel size and lifting speed are set in the embroidery parameters.
