Ricoh V-C3, Technical Training Manual

Page: 354 / 548

V-C3 Training
354
Slide 354
Installing a New PCU - 1
!
Remove the seal with the bar
codes. Use these numbers
later to input into the SP
mode
"
SP 3010, 3011, 3012, or
3013, depending on the
PCU color.
"
These are TD sensor
calibration characteristics.
"
You can attach the seal to
a sheet of paper that
comes with the new PCU,
as a convenient means of
reference.
!
The settings must be made if
you install a new
development unit or a new
PCU.
!
Do these SPs before you do
the developer initialization.
#
The settings are on the SMC list, so that they can be input again in the case of
NVRAM failure.