Ricoh V-C3, Technical Training Manual

Page: 100 / 548

V-C3 Training
100
Slide 100
Initializing Developer and Toner
Overview
!
The procedure must be done exactly as stated in the
manual.
!
You must open the front door before you turn the power on.
"
This prevents initial process control from starting
automatically.
"
If you forget, then you must change all the developers.
!
Turn the power on. Then, ‘Open Cover’ will be shown on the
display. Then, you can close the front door.
!
After you close the front door, you can do SP 3811 001.
!
This adds toner, initializes the TD sensor, and does process
control.
"
Do not use SP 3801 or 3811 again, to initialize the TD
sensors again, until the next time you replace the developer.
Otherwise, you will cause toner scattering inside the
machine. To cure this, you must replace the developer.
"
Only use the SP modes for initializing developer at the times
stated in the service manual.
V-C3 field service manual, Installation, Copier, Installation,
Initializing Developer and Toner
#
This slide shows the important points about initializing the machine.