Ricoh SR4080, Field Service Manual

Page: 23 / 74

Stack Feed-out Belt, Jogger Fence
Stack Feed-out Belt
1. Open the front door.
2. Pull out the jogger and stapler unit.
3. Remove the inner cover [A].
4. Remove the sensor bracket [B].
5. Remove the front guide [C].
6. When re-installing, make sure that the flat end of the shaft is against the plate.
7. Remove the front panel [D] from the stays.
8. Remove the old belt [E] from the bottom, center, then the top.
9. Make sure the ribbed side of the new belt and pawl [F] are facing down.
10. Make sure the new belt is engaged at all three rollers.
Jogger Fence
1. Open the front door.
2. Pull out the jogger and stapler unit.
3. Push both fences to the center.
4. Remove the left jogger fence [A].
5. Remove the right jogger fence [B] .
6. If the screws are difficult to remove or re-attach, remove the jogger fence belt and spring plate.
Stack Feed-out Belt, Jogger Fence
21