3
G
Pull out tray 2 of the printer slow-
ly until it stops, lift the front of
the tray slightly, and then pull out
the tray completely.
Place the tray on a flat surface.
H
Attach a screw in the hole on the
left side of the tray opening to se-
cure the printer to the paper feed
unit.
Tighten the screw firmly using a
coin.
I
Lift the front of the tray, and slide
it carefully into the printer until it
stops.
J
On the rear of the unit, attach two
brackets using the remaining
screws.
Tighten the screws firmly using a coin.
K
Plug in the power cord, and then
turn on the printer.
L
Print the configuration page to
confirm that the unit was attached
correctly.
Note
❒
To confirm whether the optional
paper feed unit was correctly at-
tached, print the configuration
page, and check "Attached Equip-
ment" on the configuration page. If
the unit was attached correctly, the
following will be displayed:
• 1000-sheet paper feed unit:
Lower Paper Trays
• 2000-sheet paper feed unit: Tray 3
❒
If the optional paper feed unit was
not installed properly, repeat the
procedure from step
2
. If it cannot
be installed correctly even after reat-
tempting installation, contact your
sales or service representative.
Reference
For information about printing the
configuration page, see "Test Print-
ing",
Quick Installation Guide
If the print area is not centered cor-
rectly, see "Adjusting Printing Po-
sition",
Hardware Guide
BEK103S
BEJ115S
BEK105S
BEK106S
AlexP1_pera_pfu-GB-F1_FM_forPaper.book Page 3 Thursday, April 24, 2008 5:34 PM
