Ricoh LP031c, Option Setup Manual, Page: 22 / 40

Options
18
1
IIII
Secure the controller board to the
machine by tightening the top
and bottom screws using the
screwdriver provided.
Note
❒
After finishing installation, you
can check whether the memory
unit is installed properly. Print
the configuration page from the
“List/Test Print” menu. If it is
installed properly, you will see
the memory capacity for “Total
Memory”.
❒
The table below shows SDRAM
module total memory capacities.
❒
If the memory unit is not in-
stalled properly, reinstall it from
step
A
. If you cannot install it
properly even after attempting
reinstallation, contact your sales
or service representative.
Reference
For printing the configuration
page, see “Printing a Configura-
tion Page”,
Administrator Refer-
ence .
Important
❒
Before using the new memory
unit, you must make settings in
the printer driver.
Standard Extended Total
128 MB 64 MB 192 MB
128 MB 256 MB
256 MB 384 MB
AAL137S
PlutoP1EN_setup-F_FM_ZF.book Page 18 Monday, March 1, 2004 6:36 PM