Ricoh JP3000, Service Manual, Page: 158 / 693

SERVICE PROGRAM TABLE
4-22
C231/C237/C238 SM
4. SP Mode No. 87 - Memory Print
Normally, in Platen mode (when no originals are placed in the ADF) in combination
with Memory mode, the machine stops when the 1st print job is finished even if the
tape marker is installed, so that the next original can be placed on the exposure
glass. The next printing job (with the number of prints that has been set with
Memory mode for the next original) starts when the Start key is pressed.
If "1" (Stack) is selected in this SP mode, after the 1st print job is finished, the next
print job starts immediately afterwards. (The tape marker feeds a strip of tape to
separate the jobs if it is used.)
In Platen mode in combination with Memory mode, the machine can print
continuously depending on the numbers set with Memory mode for each print set,
without replacing the original.
5. SP Mode No. 88 - Auto Memory/Class
In Memory/Class mode, the machine normally stops when the first print job is
finished if the tape marker is not installed.
If "1" is selected in this mode, the machine stops for a while (this interval is the
same as when the tape marker is operating). Then it continues with the next print
(or master making) job.