Ricoh InfoPrint 1754dn, User Manual

Page: 16 / 110

Installing memory and option cards
16
Installing and removing options
Installing a memory card
Follow the instructions in this section to install a printer memory card. Memory cards must have 100-pin connectors.
Note: Memory cards designed for other printers may not work with your printer.
1 Remove the system board access cover. For more information, see Removing the system board access cover .
Warning: Memory cards are easily damaged by static electricity. Touch something metal on the printer before
you touch a card.
2
Unpack the memory card.
Avoid touching the connection points along the edge of the card. Save the packaging.
3
Push open the latches on both ends of the memory connector.
4
Align the notches on the bottom of the card with the notches on the connector.
5
Push the memory card firmly into the connector until the latches on either end of the connector snap into place.
It may require some force to fully seat the card.
6
Make sure each latch fits over the notch on the end of the card.
Installing an “option-added” firmware card
Follow the instructions in this section to install an optional “option-added” firmware or flash memory card.
Note: “Option-added” firmware and flash memory cards offered for other printers cannot be used with your
printer.
Only one of each type of card is supported.
Warning: “Option-added” firmware and flash memory cards are easily damaged by static electricity. Touch
something metal on the printer before you touch a card.
1
Remove the system board access cover. For more information, see Removing the system board access cover .
2
Unpack the card.
Avoid touching the metal pins on the bottom of the card. Save the packaging.
Latch
Notch
Connection
points
Memory card
connector