D392 Ring Binder Training
83
Slide 83
Adjusting SP6504 if the Hole
Position is Incorrect - 2
For example, if X1 is measured at "9.65“, this does not match the
standard for LT (X1 = 9.525). The hole is too high up the page.
Subtract the measured value (9.65) from the standard value
(9.525) and multiply it by "2".
9.525 - 9.65 = -0.125 x 2 = -0.250
Add "-0.250" to the setting of SP6504
The actual adjustment is done by adjusting the movement of the pre-punch
jogger fences so that the hole-punch position is lowered "-0.125".
The firmware does this automatically by dividing the entered value (-0.25) by 2 (-
0.125), so 9.65 – 0.125 = 9.525 mm.
In our example above, the measured distance is more than the standard value.
¾
If the measured distance is less than the standard value, then the
adjustment must raise the hole-punch position. The setting of SP6504 must
be made larger in order to raise the hole position.
Summary of Contents for D392
