Ricoh D023, Service Manual, Page: 1414 / 1522

Bit Switches
SM 73 D393
Fax Op
tion
T
ype C50
00
(D
39
3)
1-3 Not used Do not change these settings.
4
Dialing on the ten-key pad
when the external telephone is
off-hook
0: Disabled 1: Enabled
0: Prevents dialing from the ten-key pad while the
external telephone is off-hook. Use this setting
when the external telephone is not by the
machine, or if a wireless telephone is connected
as an external telephone.
1: The user can dial on the machine’s ten-key pad
when the handset is off-hook.
5
On hook dial
0: Disabled 1: Enabled
0: On hook dial is disabled.
6-7 Not used Do not change the factory settings
System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
System Switch 0E [SP No. 1-101-015]
No FUNCTION COMMENTS
0-1 Not used Do not change the settings.
2
Enable/disable for direct
sending selection
0: Direct sending off
1: Direct sending on
Direct sending cannot operate when the capture
function is on during sending. Setting this switch to
"1" enables direct sending without capture. Setting
this switch to "0" masks the direct sending function
on the operation panel so it cannot be selected.
3
Action when the external
handset goes off-hook
0: Manual tx and rx operation
1: Memory tx and rx operation
(the display remains the
same)
0: Manual tx and rx are possible while the external
handset is off-hook. However, memory tx is not
possible.
1: The display stays in standby mode even when
the external handset is used, so that other people
can use the machine for memory tx operation.