Beluga-C1/C1.5 Training
69
Slide 69
Testing the Breaker Switch
The machine power must be off.
The power cord must be connected to the power source.
Test the breaker switch.
Push the button with the screwdriver until the ‘O’ appears.
Then manually turn the switch to the ‘I’ position.
This switch must be tested once a year.
If the breaker switch does not drop to the “O” position:
¾
Make sure that the power cord is securely connected to the power supply.
¾
Push the test button again.
¾
If the breaker switch does not snap down to the ‘O’ position, the breaker
switch must be replaced.
The breaker switch must be at the “I" position for the machine to operate.
Summary of Contents for Beluga-C1
Page 110: ...Beluga C1 C1 5 Training 110 Slide 110 INSTALLATION Updating Firmware No additional notes ...
Page 236: ...Beluga C1 C1 5 Training 236 Slide 236 Exit Guide Open here to remove jams No additional notes ...
Page 253: ...Beluga C1 C1 5 Training 253 Slide 253 End of Course No additional notes ...