1 October, 1999
INSTALLING OPTIONAL UNITS
3-5
InstallationInstallation
6. Pull out the stapler unit [D].
7. Draw out the locking lever [E] (1 screw).
8. Align the finisher on the stands, and lock it in
place by pushing the locking lever.
9. Secure the locking lever (1 screw) and push
the stapler unit into the finisher.
10. Secure the finisher (1 screw).
11. Adjust the securing knobs [F] under
the front and rear stand until the
finisher is perpendicular to the floor.
12. Install the shift tray [G] (1 snap ring).
NOTE: Make sure that the three pegs
[H] fit into the slots [I]
properly.
13. Connect the finisher cable [J] to the
optional bridge unit.
14. Turn on the main switch and check
the finisher operation.
End of procedure
A681I502.WMF
A681I103.WMF
[D]
[E]
[F]
[G]
[H]
[I]
[J]
