Ricoh 7700W, Operating Instructions Manual

Page: 55 / 95

Settings You Can Change with User Tools
45
3
• Auto Off Time(+15): You can set the time the machine waits after the last op-
eration before switching itself off automatically. The time can be set by
minute from 1 to 240 minutes.
Note
❒
Default: 30min
❒
Auto Off cannot be used in the following cases.
• When the Wait indicator goes on
• When the toner end indicator goes on
• When the front door is open
• While copying
• When a paper misfeed occurs or SC call appears
• The machine cannot enter the Auto Off mode if the roll end indicator
lights while copying repeatedly.
• Original Hold Mode(+16): After original scanning is finished, the original
exit roller stops before completely feeding out the original. This is to prevent
the original from dropping onto the floor after scanning. The original is fed
out when the X key is pressed or when the next original is inserted.
Note
❒
0: No, 1: Original Hold Mode
❒
Default: 1
• Length Size Magnifi17): Adjust the speed of the original feed motor.
The setting can be changed from —1.0 to 1.0 by 0.05% steps.
Note
❒
Default: 0.0
• Synchro-cut Length Adju19): Adjust the cut length in the synchro
cut, preset cut, and variable cut modes . The setting can be changed from —
25 to 25 by 1mm steps.
Note
❒
Default: 0
• Paper Length Up/Down S20): Select if the paper length is count
down or up when the preset cut key is pressed.
Note
❒
0: Down count, 1: Up count
❒
Default: 0
• Paper Length Up/Down Speed S21) :The copier can scroll through
the preset lengths forward or backward, and at different speeds. There are
many sets of sizes from which to choose.