GTR207 Installation Manual:
Rev 1b
11
Step 2 - Mounting the Low Voltage Power Supply
For your convenience the GTR207 gate motor is supplied with 30m of cable, prewired to a low voltage power supply. This
will allow you to mount your low voltage power supply beside a standard domestic 10AMP 240Volt power point (in your
garage or next to an outdoor power point). The low voltage power line can then be ran to your gate entrance to power your
gate opener. The 2 core cable supplied is suitable for direct burial without needing to be run through electrical conduit.
Measure the distance from the power supply to your gate
• Place the motor approximately where you want it to sit near the gate
• Run the 30m cable from the gate motor to your desired mounting postion.
Please ensure that enough cable is left for the motor to be positioned and installed.
Any excess cable length should be cable tied and secured out of the way of moving objects.
There are 2 main methods that can be used for running the cable when installing the power supply:
Option 1:
Run the cable across the yard/property and bury it.
Option 2:
Run the cable along the fence line of the property and secure out of the way.
For added protection the cable can be run through electrical conduit.
To mount the low voltage power supply
box to a masonry wall (brick/concrete):
• Drill 8mm diameter holes with a masonry drill bit.
• Tap in 8mm diameter wall plugs and secure the
box to the wall using 10 guage screws.
To mount the low voltage power supply
box to a timber surface:
• Pilot drill the marked holes.
• Secure the box with 10 guage timber screws.
Mount The Low Voltage Power Supply
• Place the low voltage power supply in the
desired mounting position
• Using a marker, mark the (4) positions for
your anchor bolts ready for drilling
(refer to fig 08)
Fig 05
Fig 06
Fig 07
Fig 08
Please Note:
Your power outlet should be no more than 1m from the low voltage power supply.
Please Note:
fasteners for mounting the low voltage power supply are not included in this kit
Low Voltage
Power Supply
Gate
Motor
30m
Cable
Option 01
Low Voltage
Power Supply
Gate
Motor
30m
Cable
Option 02
Fig 09
185mm
200mm
6.5mm
Mounting
Hole
80mm Thickness
170mm
95mm
120mm
