GTR169 Electric Lock Manual
Rev 1
3
Installation for Double Swing Gate
Step 1:
Disengage the clutch of the swing arms with the Manual Release Key. You can move the gate by
hand, so the gate can swing freely during installation of the Electric Lock.
Step 2:
With the gates in the closed position, determine the best location for the lock and receiver . The
lock and receiver must be level and aligned with the swing arms. The lock and receiver should
have a solid surface or tube fence to provide stability.
Step 3:
For
Metallic Tube Gates,
if the thickness of the fence post is bigger than or equal to 3mm, you
can thread on the fence post, and fasten the lock and receiver only using bolts (without nuts).
Otherwise, drill holes throughout the fence post and fasten the lock and receiver with bolts, lock
washers and nuts. Of course you could also weld them directly.
For a
Chain Link Gates,
you will need U Bolts, saddles, lock washers and nuts for the lock and
receiver.
Step 4:
Recheck the locks position and alignment, make sure the electric lock is working correctly.
Step 5:
Connect the power cables for the lock to the control board of swing gate opener and Lock plus
board. (See Figure E and F).
Note: Be sure that the clutch of the swing arms is engaged before you prepare to activate
your opener (Use the Manual Release Key)
