GTR169 Electric Lock Manual
Rev 1
2
Installation for Single Swing Gate
Step 1:
Disengage the clutch of the swing arm with the Manual Release Key. Make sure you can move the gate
by hand, so the gate can swing freely during installation of the Electric Lock.
Step 2:
With the gate in the closed position, determine the best location for the lock and receiver. The lock and
receiver must be level and aligned with the opener. The lock and receiver should have a solid surface or
tube fence to provide stability
Step 3:
For a
Metallic Tube gate,
if the thickness of the fence post is bigger than or equal to 3mm, you can
thread on the fence post, and fasten the lock and receiver only using bolts (without nuts). Otherwise, drill
holes throughout the fence post and fasten the lock and receiver with bolts, lock washers and nuts. Of
course you could also weld them directly.
For a
Chain Link gate,
you will need U Bolts, saddles, lock washers and nuts for the lock and receiver.
Step 4:
Recheck the locks position and alignment, make sure the electric lock is working correctly.
Step 5:
Connect the power cables for the lock to the control board of swing gate opener and Lock plus board.
(See Figure E and F).
Note: Be sure that the clutch of the swing arm is engaged before you prepare to activate your
opener (Use the Manual Release Key)
