Richen EF42C, Instruction Manual

Page: 15 / 51

29 28
EN
NOTE: Remote control can be used only when the main power switch
is on. Aim the remote control at the remote receiver (see last picture)
which is on the top right of the firebox.
RESETTING THE THERMAL CUT OUT
The appliance is fitted with an Electronic Safety Control (E.S.). This is a
safety device, which switches off the fire if, for any reason, the appliance over-
heats, e.g. when covered. If the heater stops operating while the flame effect
continues working normally, this indicates that the E.S. Control is in operation.
The E.S. Control can only be re-set after the appliance has cooled down,
and the appliance has been reset. Re-setting of the E.S. Control proceeds is
as follows:
1. Switch off the appliance (Manual On / Off switch) and leave it off for
approximately 10–15 minutes.
2. Remove any obstruction to the fan heater outlet or fan blades etc.
Make sure that the power supply is disconnected with the plug socket
outlet while doing this.
3. Switch on the appliance and the E.S. Control will be re-set.
4. Ensure that the appliance is functioning correctly. If the E.S. Control
doesn't operates again, the appliance should be checked by a
competent electrician.
EN
WARNING! Abrasive cleaners should not be used on the glass panel.
Liquids should not be sprayed directly onto any surface of the unit.
REMOTE HANDSET BATTERY REPLACEMENT
The remote control runs on one CR2032 lithium long-button cell batter y.
Make sure that the batteries are correctly installed in the remote control.
MAINTENANCE OF MOTORS
The motors used on the fan and flame effect are pre-lubricated for extended
bearing life and require no further lubrication. However, periodic cleaning
/
vacuuming of the fan / heater unit is recommended.
CLEANING THE FIREPLACE
You can clean the exterior of the fireplace with a soft, damp, lint-free cloth.
Do not use cleaning or polishing products. To remove fingerprints or other
marks on the front glass panel, use a soft, damp, lint-free cloth with a good
quality household glass cleaner. The front glass panel should always be
completely dried with a clean, lint-free cloth or paper towel.
MAINTENANCE
WARNING! Before any maintenance or cleaning of the exterior of the
fireplace, the unit should be disconnected from the power supply until it
is cool off.