3
Warnings!
Important!
Cautions!
l
If the product has been installed correctly, the top of the gate
(while looking down from above the top) will be as straight as
a line with each end aligned at a 90-degree right angle as
shown in Figure 3.
l
If this product is installed incorrectly, the Door may not close
and/or lock.
l
Make sure the bottom of the Main Frame touches the Floor
as shown in Figure 1. A gap between the floor and the bottom
of the Main Frame indicates that the gate has not been properly
installed.
l
The product must be set at a perpendicular right angle with the floor
and the wall, otherwise the Gate Door may not close automatically.
l
The width of the Adjuster Bolts on each side must be set equally to
avoid unexpected accidents and/or product damage as shown in
Figure 5.
l
When using an Option Frame, the width of the Adjuster Bolts can
not be longer than 2.2" as shown in Figure 5 (bolts longer than 2.2"
will not secure Main Frame fully).
l
Tighten the Adjuster Knobs until clearance between the Gate Door
and Main Frame is set to 0.04 - 0.08" . This allows the tension-spring
effect to work properly to avoid unexpected accidents and/or product
damage.
Figure 3
Longer
than 2.4"
Shorter
than 2.4"
Figure 4
Figure 2
Adjuster Knob
Adjuster Knob
Rubber Part
Pull
Screw
Figure 6
The side of the Main Frame
should be parallel to the wall.
One side of the Adjuster
Knob is longer than the
other side.
One side of the Adjuster
Knob is shorter than the
other side.
The side of the Main Frame
should be parallel to the wall
surface even if there is a
baseboard.
Figure 5
Right
angle
Right
angle
90° angle with Floor
90° angle with Floor
90° angle with W
all
Door
0.04 - 0.08"
Less than 2.2"
Lock pin
Main Frame
Left and Right
Adjuster is the
same length
