Page 2
Press/hold power button (7) for 3 seconds
LCD (6) shows remaining charge capacity 0 -100%
Press/hold power button for 3 seconds to shut off
LCD shuts off automatically in 60 seconds if no buttons are pushed
Connect intelligent jump start cables (13) to EC5 jump start socket (2)
Flashing RED/BLUE LED indicators on jump start cable module =
system is working properly
Press/hold jump start power button 3 seconds to power on
Make sure vehicle battery terminals are free from rust, dirt, and corrosion
Connect RED cable clamp to positive (+) battery terminal on vehicle
Connect BLACK cable clamp to negative (-) battery terminal on vehicle
Look for GREEN LED indicator on module and start vehicle immediately within 30 seconds
When motor starts, remove clamps immediately from battery terminals
•
For best performance when starting vehicles, use Jump Starter at 30% charge capacity
or higher.
•
DO NOT connect jump start cable clamps to wrong +/- battery terminals — RED = (+)
positive / BLACK = (-) negative
•
DO NOT connect jump starter RED/BLACK cable clamps together
•
Make sure Jump Start cable clamps are connected securely to battery terminals
•
Always remove clamps within 30 seconds after motor starts
•
Check battery terminals for rust, dirt, and corrosion before using Jump Starter — clean
if necessary to avoid poor performance
•
DO NOT jump start again after 3 attempts to avoid damaging Jump Starter — check for
other vehicle issues
•
Short circuit
•
Over-current output
•
Low voltage limits
•
Reverse polarity
•
Overheating
•
Over voltage limits
•
Overcharging
•
Overload
• Dimensions: 6.5" x 3.9" x
1.95" (164.5 x 99 x 49.5mm)
• Weight: 1.68 lb (0.76 kg)
• Capacity: 12,000 mAh
• Cell Type: Li-polymer battery
• Type-C input: 5V/2A
• USB output: DC 5V/2A
• Start current: 600A
• Peak current: 1000A
• Air-pump power:
0-150 PSI (max)
• Inflation efficiency: 20L/Min
• Inflator speed: 15 minutes
— Tires up to 17” (0-100%)
• Operating temperature:
-4~140 degrees F (-20~60C)
• Storage temperature:
-4~140 degrees F (-20~60C)
• USB-C / USB-A charge cable
length: 20” (50.8 cm)
• Jump start cable length:
12" (30.5 cm)
• Inflator hose length:
12" (30.5 cm)
• Full charging time:
About 6 hours
• Nylon storage case: 9" x 5" x
4" (23 x 12.7 x 10.16 cm)
• 12000 mAh Jump Starter /
Air Pump / Power Bank
• USB-C / USB-A charge cable
• Inflator hose
• Inflator adapters (3)
• Jumpstart cable
• Storage case
• Printed instructions
Check remaining power bank capacity
Jump-start instructions
Notes for jump starting 12V vehicle batteries
Includes 8 protection characteristics
for safe jumpstarts
Specifications
Package Contents
1
1
2
2
3
4
3
4
5
6
7
8
12000 mAh Portable Jump Starter / Air Pump / Power Bank
Model: TY001
Questions? Please email us at: [email protected]
2301 Kerner Blvd. Suite C, San Rafael, CA 94901, USA
www.RichardSolo.com
