Rice Lake LaserLight Series, Installation Manual, Page: 9 / 46

Installation/Setup
© Rice Lake Weighing Systems ● All Rights Reserved 5
2.2 Enclosure Disassembly
For ease of installation, remove the mounting plate (which includes the primary and secondary display boards) before installing
the LaserLight remote display. This protects the LEDs from unnecessary jarring and makes the enclosure lighter for installation.
Use the following steps to remove the mounting plate from the enclosure.
Use caution when lowering/raising the mounting plate to ensure LEDs do not contact the enclosure sides.
1. Remove the captive screws located on the bottom of the enclosure. The mounting plate is located on the inside of the
enclosure, on a frame which can be held in place by tabs and two pins ( Figure 2-2 ).
2. Glide the mounting plate frame downward, allowing it to hang freely beneath the enclosure.
3. Disconnect the chassis ground wire from the top of the mounting plate mounting frame.
4. Disconnect the AC cord assembly from the power supply.
5. Using a slight diagonal twisting motion, slide the mounting plate out from the inside of the enclosure and set it aside.
Figure 2-2. Tab Pin Assembly on Inside of Remote Display Enclosure
2.3 Wall Mounting
The LaserLight remote display can be mounted to vertical surfaces or a pole.
Select a site and use installation screws or wall anchors to secure the remote display to a wall using the mounting holes on the
flange tabs. The flange hole size accommodates 1/4" hardware.
Figure 2-3. Mounting Flange 4'' LED Remote Display
An optional pole mounting kit, which fits 4" - 8" poles, must be used when installing a remote display on a pole ( Section 4.4 on
page 25 ).
Once the enclosure is secured, slide the mounting plate down to allow it to hang freely from the enclosure with the tabs secured
against the pins. This enables the user to continue wiring the remote display.
IMPORTANT
Flange tab with holes to
accommodate 1/4"
hardware for mounting