LaserLight Series
4
Visit our website
2.0
Installation/Setup
The LaserLight remote display can be set up and configured once it is mounted. This section describes basic installation,
AC wiring, RS-232, RS-485 and 20 mA current loop connections. Once installation setup is complete, see
for information on configuring the remote display.
The LaserLight has no on/off switch. Before opening the unit, ensure the power cord is disconnected from the
power outlet.
Use a wrist strap to ground yourself and protect components from electrostatic discharge (ESD) when working
inside the enclosure.
This unit uses double pole/neutral fusing which could create an electric shock hazard. Procedures requiring
work inside the remote display must be performed by qualified service personnel only.
2.1 Unpacking and Assembly
Immediately after unpacking, visually inspect the LaserLight remote display for damage. If parts were damaged in shipment,
notify Rice Lake Weighing Systems and the shipper immediately. The main components of the LaserLight remote display
include:
• Powder coated steel or stainless steel enclosure
• Primary and secondary display boards
• Power supply
• Mounting panel for the CPU board (located on back of mounting plate)
Remove the protective plastic on the lens of the LaserLight as it obscures the display over time and becomes
very difficult to remove later on.
Figure 2-1. Mounting Plate Indicating Primary / Secondary Display Boards (7-Segment Display)
WARNING
CAUTION
IMPORTANT
Primary Display
Secondary Display
Summary of Contents for LaserLight Series
Page 44: ...LaserLight Series 40 Visit our website www RiceLake com...
Page 45: ......