Rice Lake LaserLight Series, Installation Manual, Page: 18 / 46

LaserLight Series
14 Visit our website www.RiceLake.com
CONFIG Menu
7-Segment
Display Parameter
8-Character
Matrix Display
12-Character
Matrix Display Choices Description
Level 2 Submenus
TIMDAT TIMEDATE TIME/DATE Enabled To enable time and date
Format Displays USA or ISO time format
Set Sets hours/minutes and month/day/year
Date Can disable date
TEMP TEMP TEMPERATURE F Select Fahrenheit
C Select Celsius
TEMPADJ TEMPADJ DEGREE
ADJUST
+5% ±5° display; Can add or subtract up to ±5° of both Fahrenheit or
Celsius
-5%
BRIGHT BRIGHT BRIGHTNESS Day Selects the brightness during day or nighttime hours
Night
SUPP O SUPP O SUPPRESS 0 On Select On to enable the suppression of leading zeros in a weight
Off
MIRROR MIRROR MIRROR On Select On to display LED readout in reverse; The menu is viewed
normally
Off
STDSTL STD STL STAND STILL On Select On to enable display updated weight only when the scale
is not in motion
Off
ADDRES ADDRESS ADDRESS 0 –31 Assign a command address by selecting a number between 0–31
MSG TM MSG TIME MESSAGE TIME 5 seconds Select amount of time a message stays on the remote display;
Time can vary from 5 seconds to 5 minutes; If no serial command
is used then this parameter is not used (7-segment DM
command only)
15 seconds
30 seconds
1 minute
5 minutes
D TEST DSP TEST DISPLAY TEST On Set this parameter On to enable a countdown display test on
start up
Off
RESET RESET RESET CONFIG -- Resets the remote display to default parameters
LEARN EN LEARN EN LEARN EN On Enable allows weight learn operation; With Learn off, the unit
operates for demand messages
Off
Table 3-2. Configuration Menu Summary - Level 2
Parameter Choices Description
Level 3 Submenus (TIMDAT Parameter)
ENABLE On An additional chip called a “snap hat” is required; Select On to enable time and date option; It is recommended to disable
the time/date feature if this additional chip is not wanted; The unit displays at zero or less weight only
Off
FORMAT USA Displays USA format
ISO Displays ISO (military time) format
SET HH/MM Sets hour/minutes
MM/DD/YYYY Sets month/day/year
DATE On Select Off to disable the date display if the date and time option is installed; Time is still displayed
Off
Brightness (BRIGHT Parameter)
DAY
1– 10 Selects the brightness during day; Brightness is set from 1–10 or 10–100% of the full brightness; IntelliBright averages
measured ambient light over a ten minute time span
NIGHT 1– 5 –10 Selects the brightness during night; Brightness is set from 1–10 or 10–100% of the full brightness; IntelliBright averages
measured ambient light over a ten minute time span
Table 3-3. Configuration Menu Summary - Level 3