Configuration Settings
13
keypad. The first SPEC code is displayed.
The
VALUE/$
display shows what specification you are in (in this case, SPEC00). The
Denomination
display shows how this specification is currently programmed (Bit 3 = 0; Bit 2 = 0; Bit 1 = 0, and Bit 0 =
0 in this example, while the
Weight
display will show any changes you enter.
If this is the SPEC that you want to modify, enter the new setting from the numeric keypad and press the
* CONFIRM
key to enter the change into temporary memory and move to the next SPEC code.
2. Use the
+
(plus) and
–
(minus) keys to scroll through the specifications until you find the one you want.
Then make your changes per the instructions in Step 1. Alternatively, you can go directly to a specific
specification by entering that specification’s number and pressing the
SHIFT
key (Example: 9 +
SHIFT
will bring up SPEC 09; 11 +
SHIFT
will bring up SPEC 11).
3. To change another SPEC code before exiting, repeat Steps 1 and 2.
4. To save all the changed SPEC settings currently in temporary memory and exit to the Weighing Mode,
press the
TARE
key.
Table 3-1. DMC-782 (141) Settings
SPEC
No.
Bit 3
Bit 2
Bit 1
Bit 0
00
Auto Power-off function (for no key operation and weighing operation)
0000: Auto power-off disable when scale is not in use (DEFAULT)
0001: 3 minutes
0010: 10 minutes
0011: 30 minutes
0100: 1 hour (DEFAULT0
0101: 3 hours
0110 ~ 1111 - not used
01
Buzzer
0: On (DEFAULT)
1: Off
Error alarm
0: On (DEFAULT)
1: Off
Tare override
0: On
1: Inhibit (DEFAULT)
Not used
0: (DEFAULT)
02
Backlight function
00: Auto
01: Always on (DEFAULT)
10: Always off
11: Not used
Auto backlight interval
00: 6s (DEFAULT)
01: 15s
10: Not used
11: Not used
03
Extent of insufficient samples
00: 0.1% (DEFAULT)
01: 0.2%
10: 0.0%
11: Not used
04
Sampling time for unit
weight calculation
0: 10 times (DEFAULT)
1: 5 times
Negative counting
0: Allow (DEFAULT)
1: Inhibit
Re-Zero function
0: Allow (DEFAULT)
1: Inhibit
5 – 19
Not used
(reserved for future use)
