Installation
5
2.0
Installation
This section describes the procedure for the installation and setup of the DC-782 counting scale.
2.1
Unpacking
Do not turn scale upside down. Always work with scale on its side! Damage to the load cell can occur if
the scale is turned upside down.
1. Immediately after unpacking, visually inspect the DC-782 counting scale to ensure all components are
included and undamaged. If any were damaged in shipment, notify Rice Lake Weighing Systems and the
shipper immediately.
2. The DC-782 counting scale is carefully packed for protection during shipping. After opening the box,
remove all the components. Check the insides of the box carefully to make sure you have all of the
pieces. The package should include the following:
•
DC-782 counting scale
•
Stainless steel platter
•
AC power cord
•
Operation manual
3. Remove the bag protecting the scale and the protective film covering the front panel and platter.
4. Seat the stainless steel platter on the platter supports, with the four corner pins inserted into the corner
rubber stops.
5. After ensuring that all parts are present, store the DC-782 scale box for possible future use.
2.2
Repacking
If the DC-782 counting scale must be returned for modification, calibration or repair, it must be properly packed
with sufficient cushioning materials. Whenever possible, use the original carton when shipping the DC-782.
Damage caused by improper packaging is not covered by the warranty.
2.3
Setting Up
Place the scale on a solid, level surface away from fans, breezes, and sources of electrical interference.
Level the scale by turning the four adjustable legs located on the bottom of the scale while referencing the bubble
level located on the front of the scale (see Figure 2-1).
NOTE:
To ensure a higher degree of scale stability, turn in all four adjustable legs before leveling. Turn out adjustable legs to
level as needed.
#AUTION
#AUTION
All manuals and user guides at all-guides.com
