Do not use hot water otherwise the filter may warp.
-
Do not use detergents. Leave the filter to dry naturally before replacing it in its housing. Do not place it
close to hot sources of heat. Do not place it in direct sunlight.
-
It is advisable, in any case, to clean a max. of 2/3 kg of ash during each cleaning operation.
-
When the stove or fireplace has been cleaned, the appliance and suction filter must then be cleaned
as
described above. The cleaning operations should be done outdoors.
-
Position the steel pipe in fitting (fig.3) by jointing the connection supplied with the machine (fig.4) and turn
the appliance on using the switch. Direct the outlet of air towards the filter and, if necessary, shake the filter
with the metal nozzle located on the outside of the pipe.
-
Once the filter has been cleaned, check whether it is suitable for further use. If it has been damaged or broken,
replace it with an original Ribimex HEPA filter.
-
To take out the filter, remove it forcefully.
-
To insert the new filter, press on it as far as it will go.
PREFILTER FOR HEPA FILTER
The prefilter, applied over the HEPA filters, prevents the ash to get in contact with the filter lengthening the duration of
suction.
To ensure efficient suction, fit onto the HEPA filter (fig. 1) the fabric pre-filter as shown in fig. 2.
With the prefilter completely applied (Figure 3), use the ash cleaner as indicated in the user and maintenance manual.
For proper maintenance and suction power, the pre-filter and HEPA filter can be washed in water and must be dried
thoroughly before use
.
BLOWING FUNCTION
To use the blowing function, insert the pipe in the air outlet hole as shown in fig. 3 when the equipment is
switched off and fit the connector shown in fig. 4 that is supplied with the equipment on the end of the pipe. Turn
the ash cleaner on using the switch.
Fig.4
brush
5
Summary of Contents for PRCEN003
Page 3: ...Obr 1 Obr 2 Obr 3 3 ...
Page 14: ...14 ...
