5
NOTE:
If purchased as a complete unit, you do not need to learn in the TRANS TX
or activate TRANS TX mode.
Learn the TRANS TX into the alarm (RAM, JAG, RAv2)
1.
Turn the vehicle ignition on. Press
and hold the centre button on the
alarm remote control.
2.
When the alarm LED starts to flash
immediately release the button on the
remote control and press and hold the
button on the TRANS TX module.
3.
When the alarm LED stops flashing
release the button on the TRANS TX
and turn vehicle ignition off.
4.
To test that the TRANS TX is learnt
in successfully, disarm the alarm with
the remote control and then press
and hold the button on the TRANS TX
module until the red LED turns on.
The alarm will arm.
Activate TRANS TX Mode on the alarm (RAM, JAG, RAv2)
To activate TRANS TX Mode please refer to the relevant alarm’s register
programming instructions.
Turn the vehicle
ignition on and
then press and
hold centre
button on remote
control
Wait for LED to
flash
Release remote
control button
and press and
hold Transformer
button
Wait for LED to
stop flashing
Release button
and turn vehicle
ignition off
Disarm the vehicle with
remote. Press and hold
Transformer button until
LED turns on. The alarm
will arm
Summary of Contents for Trans TX
Page 8: ...19 www rhino com au...