RHINO Trans TX, Instruction Manual

Page: 6 / 8

17
Notes for Installation
•
• •
•
Plug the wiring harness in to the module last, after all connections have
been made.
•
• •
•
Check the vehicles electrical system thoroughly before commencing
installation.
• • • •
The installation should be as well hidden as possible - to maximise the
system security.
• • • •
Solder all connections, and then insulate with insulation tape.
•
• •
•
Use a multi - meter to verify any wires nature.
• • • •
Connect the harness to the TRANS TX module as shown below.
•
• •
•
Diodes: 1 Amp is 1N4004, 3 Amp is 1N5404.
IMPORTANT: If the installer does not have a concise knowledge of the
vehicle’s electrical system, it is strongly advised not to aimlessly probe
to find the necessary wires. Doing so may damage your vehicles
electrical system. Consult with your vehicle’s manufacturer, or a
qualified Auto Electrician. Rhino accepts no responsibility if an installer
wires the product incorrectly or damages the vehicle during installation.
CONGRATULATIONS!
INSTALLATION IS NOW COMPLETE.