FEATURES USED BY INSTALLERS / SERVICEMEN
1. INSTALLER / SERVICE MODE TEST
Installer and alarm service mode and test mode is accessed by on powering of
alarm. It is used to check each sector input when door, hood, aux or voltage drop is
triggered. A signal is given via the blinkers and the dash LED light.
Shock sensor adjustment: If a hard shock is received by the shock piezo sensor, one
second flash will be seen from blinkers. If a light shock is received by piezo sensor, a
half second flash will be seen from blinkers.
For proper adjustment of shock sensor go to the rear of vehicle and bump vehicle
until a half second flash is seen from blinkers. When the desired force is applied.
On completion of shock sensor adjustment, you can exit installer mode. This is
accomplished by pushing the button on remote control or turn ignition to on
position.
2. ALARM HISTORY MEMORY READ OUT VIA SIREN AND LED
To access alarm memory turn ignition on and hood opened i.e. bonnet switch
grounded. By pressing the remote control, alarm history is accessed via siren and
LED.
1 Beep, 1 Flash - Voltage Drop Alarm
2 Beep, 2 Flashes - Not Used On This Model
3 Beep, 3 Flashes - Shock Sensor Alarm
4 Beep, 4 Flashes - Power Fail Alarm
5 Beep, 5 Flashes - Ignition Alarm
6 Beep, 6 Flashes - Not Used
7 Beep, 7 Flashes - Door Alarms
8 Beep, 8 Flashes - Bonnet / Boot Alarm
If two previous alarms were caused by i.e. voltage drop and shock sensor the LED
will flash and siren will beep once for voltage drop, no noise for 1 second then beep
three times for shock sensor. The memory will hold ten alarm memories. The last
memory heard is the most recent alarm sector triggered.
To exit memory mode turn ignition off and close bonnet.
