RHINO LUMBERJACK 60, Operator'S Manual

Page: 72 / 132

ASSEMBLY
Assembly Section 3-4 LJ60/72 02-02
© 2004 Alamo Group Inc.
FRONT CHAINGUARD ASSEMBLY 60" MODEL
Install front chainguard as illustrated below.
Do not operate Cutter without Front Chainguard in place.
CAUTION!
NOTE: Access window must be removed for
installation of shield to gearbox. This access
window will also need to be used for mounting
slip clutch to the input shaft of the gearbox.
Shield Access window coners
should always be replaced before operating cutter. CAUTION!
DRIVELINE ATTACHMENT
Remove bolts from clutch yoke. Install clutch onto gearbox shaft and install bolts through access
window in bell shield. Tighten bolts securely.
(FIGURE 4)
GEARBOX SHIELD (FIGURE 2)
Position the bell shield over the input shaft
and align it with threaded holes in the gear-
box. Make sure access windows are facing
left and right ( Not up and down ). Install
flatwashers, mounting bolts and tighten se-
curely.
12
14
12
5
11
1
2
3
12
11
10
13
13
4
13
6
7
9
8