4
Auto Re-arm
6
OFF
If system is disarmed and a door is not opened
within 60 seconds, the system will rearm &
relock.
Central Closure
7
OFF
When on, the lock & unlock outputs become a 5
second negative pulse instead of 0.5 seconds. This
feature is for certain vehicles with vacuum central
locking or those with a central closure wire (some
BMW, Mercedes) ie doors lock, electric windows
wind up, sunroof closes automatically.
Door Lock on Ignition
8
OFF
When this feature is on, the doors will lock when
the ignition is turned to on, and unlock when the
ignition is turned to off.
Shock Sensor
Adjustment
9 6
SELECT the
level
required.
After pressing the remote 9 times to enter this
mode, turn the ignition to off. There are 8 levels
of adjustment. The factory default setting is level
6. Pressing the remote once will increase the
sensitivity by one level ie to level 7. The LED will
then flash seven times to confirm the new level.
Pressing the remote again will increase the
sensitivity to level 8 (max). Pressing the remote
again will return the adjustment to level 1(least
sensitive). Once you have adjusted the sensitivity
level to the desired setting, turn the ignition on to
exit this mode.
PAT™ Past Alarm
Trigger Memory
10 SELECT
to replay
memory.
After pressing the remote 10 times to enter this
mode, turn the ignition off. Your Rhino Alarm offers
a unique memory that stores the ten last reasons
why the alarm was triggered. This memory cannot
be erased.
2 Beeps, 2 Flashes - Shock sensor alarm
3 Beeps, 3 Flashes - Ignition
4 Beeps, 4 Flashes - Power Fail Alarm
6 Beeps, 6 Flashes - Negative trigger/Door
If two previous alarms were recorded ie voltage
drop and shock sensor the LED will flash and the
siren will beep once for voltage drop, then no noise
for 1 second then beep three times for shock
sensor.
The last memory heard is the most
recent alarm sector triggered.
Turn the ignition to
on to exit this mode.
Installer Mode
11
SELECT The
Mode
Required
After pressing the remote 11 times to enter this
mode, turn the ignition to off. This mode allows the
installer / owner to verify that each trigger of the
alarm system is working, without having to arm &
disarm the system each time & set off the siren.
The siren will beep and the blinkers will flash to
indicate a trigger eg push the bonnet switch, open
a door, hit the vehicle. The siren will beep four
times to indicate a pre-warning impact sensor
detection, or once to indicate full alarm trigger
level. Turn the ignition to on to exit this mode.
