Rhino Drive360 Installation Guide
Link: https://kb.gpsinsight.com/rhino-drive360-installation-guide/ Last Updated: November 22nd, 2021
Copyright ©2022 GPS Insight
Page 1 of 10
The installation kit contains the installation guide, one Drive360 device, one mounting bracket, one power cable,
six assorted add-a-circuit fuse holders, one security bracket, two security bracket screws, two security bracket
spacers, one mini screwdriver, and one power cable security bracket.
Additional tools and supplies you will need include dashboard panel removers, a digital multimeter, a cordless
drill, self-tapping ground screw, driver bit for screw, approximately eight cable ties, a side cutter, heat gun, a
dry/clean/lint-free cloth, a pen, a dry erase/wax tip marker, 99% Alcohol wipes and a tamper seal compound.
Installation Overview
The following steps provide an overview of the installation process:
Install Preparation.
1.
Mounting.
2.
Power Cable Installation.
3.
Verification and Registration.
4.
Frequently Asked Questions
5.
1. Installation Preparation.
Note.
If applicable, all water/ice/snow should be completely removed from the windshield. If the
outside temperature is 75 degrees Fahrenheit (24 degrees Celsius) or less, turn on vehicle defrost
until the windshield is warm to the touch. Also, place the mounting bracket in defrost airflow to
warm VHB tape.
1. Record the 8-digit device serial number (S/N) onto your paperwork.
