RHINO MOTION CONTROLS
RMCS-3001
Brushless DC motor Driver
(Max. 48VDC and 5A per phase)
Page 5
BLDC Motor Drive [RMCS-3001]
Chapter 2: Drive Overview:
RMCS-3001 is Rhino Motion Controls introductory Brushless low voltage (15–48V) DC driver
designed for smooth and quiet operation without compromising on torque and control at
higher speeds. It has short-circuit protection for the motor outputs, over-voltage and under-
voltage protection and will survive accidental motor disconnects while powered-up.
The ENABLE, BRAKE and DIRECTION inputs are optically isolated. These inputs work with
3.3V or 5V logic drive signals. Motor will run on application of 3.3V/5V to ENABLE pins. To
facilitate the direction change of Motor shaft, dedicated DIR pin is given. After applying the
3.3V/5V to DIR pin, Power reset is required. BRAKE feature provided for braking the motor
rotation.
2.1 Driver Acceptance:
Upon receiving the driver, please check the following aspects:
Make sure the driver model is consistent with that ordered.
Unpack the driver and make sure it is free from damage and no part is missing.
Make sure that all sets of screws in the driver are securely tightened.
2.2 Key Features:
Smooth and quiet operation at all speeds and extremely low motor heating
DC Input supply voltage rated at 15V to 48V
Delivers up to 5A of continuous current
Rated current : 5A
Peak current : 20A
2.5V, 3.3V and 5V compatible BRAKE, DIRECTION and ENABLE with 2-wire opto-
isolated interface
Short-circuit protection for the motor outputs, over-voltage and under-voltage
protection
LED indication for power and error states
Potentiometer for speed control
Potentiometer for current gain selection (Inside chassis)
Pluggable type connectors
Compact size (100mm * 75mm *25mm)
