KF-50-OTM Instruction Book KF-50 Issue 1
Page 5 KF-50 Patent Pending
1) “Out of the Box” Initial Setup:
¾
1.1) KF-50KB: See Fig. B
The KF-50KB came partially assembled to protect items from damage during
shipment. The Front and Rear Coil Guides (2)(3) have been installed up-side-
down. Loosen and remove the Coil Guide Clamp Screw (5) and remove the
Guides. Locate item (1), the Book End Stop (This is a 3/16” Diameter wire bent in
3 places) supplied in the shipping kit. Continue to the next paragraph.
Fig. B
See Fig. C. Place the short leg of the Book End Stop (1) into the hole located on
the right side of the crimper box (8). Loosen the rear 2-winged Finger Screw (9)
to allow the Book End Stop to pass, and then tighten the Finger Screw onto the
Book End Stop. Orient as shown. Fine adjustment will be made later in this
manual. Flip over and replace the longer Front Coil Guide (2) first (as shown)
then flip over the Rear Coil Guide (3) and place on top of the Front Coil Guide (2)
(as shown), Replace the Coil Guide Clamp Screw (5) to secure the guides in
place. Fine adjustment will be made later in this manual. Continue to Chapter 3.
Fig. C
