KF-50-OTM Instruction Book KF-50 Issue 1
Page 9 KF-50 Patent Pending
Chapter 2 installation Continued… See Fig. H
2.2.1) Locate the Supplied Allen Wrench (1) that fits the screws shown (2).
Remove and store these two screws. Locate the #10 X ¾” Black Screw and #8
Silver Washer (3). Using the Allen Wrench, install both the screw and washer into
the forward hole (4).
Fig. H
2.2.2) See Fig. J. Locate the #10 X 3-3/4” long screw and lock washer (1)
supplied in the shipping kit. Feed it completely through the large hole on the right
side of the KF-50 as it’s oriented and shown in Fig. J (2). Set the KF-50 along
side the coiler so that the 3-3/4” screw, now protruding out of the left side of the
KF-50, inserts into the available hole left over from the previous step in Fig. H.
Keep the KF-50 level to the top of the coiler. You will notice that the KF-50 will
position itself over the single ‘screw head’ in the coiler from previous step in Fig.
H balloon 4. Tighten the 3-3/4” screw (4) with the Allen Wrench provided. Note
the arrow position for balloon 5. From the shipping kit locate the small Allen
Wrench. At the position of arrow 5 there is a small hole in the front side of the
KF-50. Pre-installed in this hole is a set-screw that when tightened, further
secures the KF-50 to the coiler. Tightening this set-screw drives the set-screw
into the head of the single screw installed in Fig H.
Fig. J
