HEAT PUMP AND TANK ASSEMBLY
25
7.
Retrieve the drain pipe kit from inside of the heat pump module.
Feed the hose through the penetration on the side of the heat pump module
Slip the hose clamp over the upper end of the hose within the heat pump module
Push the hose over the spigot on the condensate tray located below the evaporator
Secure the hose to the spigot with the hose clamp
Extend the hose away from the base of the storage tank and heat pump module using standard
12 mm irrigation fittings
Secure the hose to the side of the heat pump module with a saddle clamp.
Step 7
feed hose through penetration
secure hose to the spigot
secure hose with saddle clamp
8.
Remove the two screws securing the front cover to the heat pump module.
Remove the front cover from the heat pump module.
Steps 8 and 10
remove front cover from heat pump module and feed through cables
9.
Position the edge of the heat pump module which is closest to the wall against the storage tank so the
screw holes in the module are adjacent to the nutserts in the storage tank.
10.
Feed the power cable and sensor cable from the lower front cover through the heat pump module so
they protrude out of the front of the module.
