#23960
P1ge 1
WARNING
Improper installation, adjustment, alteration,
service or maintenance can cause serious injury
or property damage. Refer to this manual. For
assistance or additional information, consult a
qualified installer or service agency.
CAUTION
The recommended temperature for normal
residential use is 120°F. The dial on the aquastat
does not always reflect the out-coming water
temperature, which could occasionally exceed
120°F. The variation in out-coming temperature
could be based on factors including but not
limited to usage patterns and type of installation.
Test your water at the tap nearest to the indirect
water heater.
WARNING
Hotter water increases the risk of scald injury.
Before adjusting the water temperature setting,
read this instruction manual. Temperatures at
which injury occurs vary with the person’s age
and the length of exposure.
The slower reaction time of children, elderly, and
physically or mentally challenged persons
increases the scalding hazard to them. It is
recommended that lower water temperatures be
used where these exposure hazards exist. Such
households may require a temperature setting
less than 120°F to prevent accidental contact
with hot water.
To lower water temperature use point-of-use
temperature limiting devices.
WARNING
Water heater blankets are not recommended and
will void the warranty.
THIS MANUAL HAS BEEN PREPARED
TO ACQUAINT YOU WITH THE INSTALLATION,
OPERATION, AND MAINTENANCE OF
YOUR INDIRECT WATER HEATER AND TO PROVIDE
IMPORTANT SAFETY INFORMATION.
INSTALLER RESPONSIBILITIES
Please read all instructions thoroughly before
installing or placing the indirect water heater
into service. This unit must be installed by
licensed or authorized installers, or technical
personnel that service water heating equipment.
The indirect water heater must be installed in
accordance with all local codes and ordinances.
These instructions are a guide for the correct
installation of the indirect water heater. The
manufacturer will not be liable for damages caused
by failure to comply with the installation and
operating instructions outlined on the following
pages.
CAUTION
The recommended water temperature setting for
normal residential use is 120°F/49°C.
HANDLING
Before uncrating, check for shipping damage.
Report any damage to your carrier. Note damage on
bill of lading or delivery receipt and file a claim.
FAILURE TO FOLLOW THESE INSTRUCTIONS OR ALL
APPLICABLE BUILDING CODES AND REGULATIONS
VOIDS THE WARRANTY
ON THIS INDIRECT WATER HEATER.
Read all instructions thoroughly before
attempting installation or operation of your
indirect water heater. Keep these instructions for
future reference.
Local plumbing and electrical codes must be
followed in the installation of this indirect water
heater. In the absence of a local code use the
UNIFORM PLUMBING CODE and the NFPA Code.
Local codes may supersede instructions in this
installation manual.
These instructions are a guide for the correct
installation of the indirect water heater. The
manufacturer will not be liable for damages
caused by failure to comply with the installation
and operating instructions outlined on the
following pages.
Warranty and Parts List are included.
To the Consumer:
Please read these and all component
instructions and keep for future reference.
To the Installer:
Please attach these instructions
next to the indirect water heater.
Indirect Water Heater
Instruction Manual
Rev 1 5/08
