
INSTALLATION AND OPERATION INSTRUCTIONS
1-4
TANKLESS WATER HEATER 199
SURFACE
DISTANCE FROM
COMBUSTIBLE
SURFACES
RECOMMENDED DISTANCE
FOR INSTALLATION AND
SERVICE
Front
2"
24"
Rear
0"
0"
Left Side
1.5"
6" (labels may be difficult to read with
reduced clearance)
Right Side
4"
6" (labels may be difficult to read with
reduced clearance)
Top
2"
24"
Bottom
8"
24"
Table 2: Clearance from the unit cabinet
You must provide a minimum distance below the water heater
of 8" to allow
clearance for the supplied condensation trap assembly. More clearance will
typically be required to accommodate associated water and gas piping.
FOR BRACKET USE TWO ¼” X 1¾” LAG
SCREWS WITH FLAT WASHERS INTO
STUDS. FOR METAL MOUNTING SYSTEM
USE ¼” BOLTS WITH FLAT WASHERS.
FOR BRACKET USE TWO ¼” X 1¾” LAG
SCREWS WITH FLAT WASHERS INTO
STUDS. FOR METAL MOUNTING SYSTEM
USE ¼” BOLTS WITH FLAT WASHERS.
UNIT
MOUNT BRACKET TO WALL,
HOOK UNIT OVER TOP.
Figure 2: Wall mounting of unit
1.3.1 Mobile Home Installations
TheTankless Water Heater is approved for installation in a manufactured home
(mobile home). Units installed in a mobile or manufactured home must also
conform to the Manufactured Home Construction and Safety Standard, Title 24
CFR, Part 3280 and/or CAN/CSA Z240 MH Series, Mobile Homes.
WARNING
- Exposed water piping and
associated components
(relief valves, circulators, etc.)
must not be in contact with
combustible materials. Check
local codes for required
clearances and/or provide
adequate insulation.
- DO NOT MOUNT THIS UNIT
- DO NOT MOUNT THIS UNIT
TO A HOLLOW SHEET ROCK
TO A HOLLOW SHEET ROCK
WALL USING ANCHORS. The
WALL USING ANCHORS. The
wall mounting bracket must
wall mounting bracket must
be bolted to wall studs or a
be bolted to wall studs or a
solid wall structure to support
solid wall structure to support
the combined weight of the
the combined weight of the
unit which can exceed 150
unit which can exceed 150
lbs. (68kg) once installed.
lbs. (68kg) once installed.
- Take precautions to avoid
injury during the installation
of this unit.