10. On inside surface of the ladder (H) are metal brackets pre-installed with holes for the screws (6) to pass through. Hook the metal brackets of the
ladder into the upper side rail (B) as well as the brackets on lower side rail (C). Once the ladder is set, fasten the ladder with screws (6) provided
as in
FIGURE 7 and 8
.
11. Set the bed slats (D) on the slat holders of the upper side rails (B) then fix these slats by using screws (8) provided. See
FIGURE 9
.
12. There are pre-installed wooden stopper cleats on inside of both lower side rails (C) designed to hold the set of slat roll (E). Place slat roll on both
sides of the lower side rails, with the second to the last slat on either side of the stopper cleat, to hold the slats in place. Once the slats are set,
secure this with screws (8) provided, as in
FIGURE 10
.
Fig.8
6
6
FIGURE 7
FIGURE 8
6
6
H
No use
Fig.10
D
E
FIGURE 9
FIGURE 10
7 8
/
