3
2
INSTALLATION AND SET UP
2.1
RE-INSTALLATION CHECKS
1.
Do not assemble this kit or any other component of the lift if any part appears to be damaged.
2.
Do not weld or other wise modify any portion of the lift. Such alterations may weaken the structural integrity of the lift
and void the warranty.
2.2
TOOLS REQUIRED
1.
9/16” & 3/4” Wrench or Adjustable Wrench.
2.
Drill Motor.
3.
17/32” drill bit.
CAUTION:
CONTACT YOUR RGC
MARINE DEALER IF YOU HAVE ANY QUESTIONS.
2.3
HL5-7K (48” & 60” Lifts) TRITOON SUPPORT TUBE MOUNTING
HL5-7K 48” lift only:
1.
Refer to Figure 2-1A & 2-2A.
Remove the extension tubes on the 48” lift. These tubes will not be used. Layout
the holes shown in figure 2-1A & 2-2A. Drill 17/32” holes through front & rear liftarms.
HL5-7K 60” lift only:
2.
Refer to Figure 2-1B & 2-2B.
Layout the holes shown in figures 2-1B & 2-2B for HL5-7K-60” lift. Drill 17/32”
holes in front and rear extension tubes on the 60” lifts.
